The cleaning machine is used to flush out contaminants generated or intruded into the filtration hydraulic system during manufacturing, assembly, operation and maintenance. It can also be applied to the regular maintenance and filtration of working oil, improving cleanliness, avoiding or reducing faults caused by contamination, and thus ensuring the high performance, high reliability and long service life of hydraulic system equipment.
1. Comply with the general operating procedures for casting equipment. 2. Before starting work, it is also necessary to comply
A. Check if there is any gas or water leakage in the pipeline system. If so, notify the maintenance personnel for repair.
B. Check if the cleaning solution is sufficient. If not, add more cleaning solution in time.
C. First, conduct a jog test run, then idle for 2 to 3 minutes to check if the transmission system (motor, coupling, reducer) and the movement of the conveyor belt are smooth. Only after confirming that everything is normal can production commence.
D. Start the oil skimming device (except for those without it) to begin the oil skimming. At this time, the water pump is still on and the water surface is calm, so the oil skimming effect is the best. Stop the oil skimming after the oil skimming is basically skimming. If there is a lot of oil skimming, it is recommended to do it during the lunch break.
3. One must also abide by it at work
A. The parts to be cleaned by the machine should be neatly placed on the conveyor belt and must not be pressed against the rollers.
B. On the conveyor belt, the parts to be cleaned should not be piled up too much to avoid affecting the cleaning effect.
C. After work, the parts to be cleaned must not be parked on the conveyor belt. Press the stop button to stop the entire machine.
A cleaning machine is a device that uses various methods to clean packaging containers, packaging materials, packaging accessories, and packaging items to achieve the expected level of cleanliness.
D. The cleaning solution should be regularly replenished with water and a certain proportion of metal cleaner to maintain the liquid level at a certain height. If the cleaning effect fails to meet the specified process requirements, all the cleaning solutions should be replaced.
